DC motors

• Cleaning, re-insulation, armature drying, turning and milling of the manifold.
• Control of the armature winding at the surge-test. Bearing replacement.
• Cleaning and re-insulation of the rear cover.
• Check the brushes for wear, adjust them and replace them if necessary.
• Brush holder height adjustment and linear neutral setting.
• Electrical overhaul and tacho dynamo control.
• Brake setting, torque control.
• Encoder control.
• Shaft dimensional control.
• If ventilated: checking, disassembly, cleaning, re-insulation, drying, bearing replacement, assembly and testing.
• Assembly, testing, data collection and final inspection.

Brushless Motors

• Stator cleaning, re-insulation and drying.
• Surge-test winding test.
• Replacement of bearings and gaskets.
• Brake setting and torque control.
• Emitter verification and adjustment: RLG, resolver, integrated RLG and encoder, tachometer.
• Encoder calibration.
• Rotor keyway check.
• Power and emitter connection control.
• Shaft dimensional control.
• If ventilated: checking, disassembly, cleaning, re-insulation, drying, bearing replacement, assembly and testing.
• Assembly of the motor, tests on load bench and tests with its regulator and numerical control.
• Data collection and final inspection.